Support Brackets
Connect the two upper bag supports and hanger rods using (4) 1⁄4" x 1⁄2" hex head bolts. Next, slide the support bracket assemblies into each of the mounting holes on the fan/motor assembly and fasten with (2) 1⁄4" x 1⁄2" hex head bolts. See
Figure 9.
Figure 11. Attaching dust bags.
Figure 9. Attaching the support brackets.
Hook the loops at the top of the upper bags over the support bracket hangers as shown in Figure 10. Pull the upper bag openings over the top opening of the collectors. Cinch the straps and tighten the bag clamps, securing the upper bags around the rim of the collector as shown in Figure 11.
Figure 10. Hang bags on support hooks.
4 To 1 Inlet
The dust collector can operate with up to four machines running simultaneously. Included is a 4 to 1 inlet adapter that allows up to four separate lines to connect to the main assembly. There are also two inlet caps to seal off the inlets that are not used. The inlets and inlet caps are secured to the main assembly by a press on fit.
G9958 4 H.P. Dust Collector |