5.Install the rubber gasket onto the motor/ impeller housing opening.
6.Install the collector onto the motor/impeller housing with six
Collector
Motor/Impeller Housing
Figure 8. Installing collector onto motor/impeller
housing.
7.Secure the two collection bag support rods to the base plate with four M5-.8 x 15 Phillip head screws and four flat washers, and to the collector using two M5-.8 x 15 Phillip head screws, two flat washers, and two hex nuts as shown in Figure 9.
Figure 9. Securing collection bag support rods.
G8027 1 HP Dust Collector
8.Install the upper bag support onto the collec- tor, as shown in Figure 10, using two M4-.7 x 8 Phillips head screws.
Figure 10. Installing upper bag support.
Collector Support
Bolts
1.Adjust the two hex bolts located on the col- lector support plate (Figure 11) so the bolt heads press against the motor/impeller hous- ing.
2.Tighten the hex nuts against the support