Circuit Requirements, 110V Operation

SECTION 3: CIRCUIT REQUIREMENTS

110V Operation

Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.

Amperage Draw

The 1⁄20 HP motors on the Model G9955 will draw the following amps:

110V Motor Draw

0.4 x 2 Amps

Circuit Breaker Requirements

Install your machine on a dedicated circuit to reduce the possibility of tripping the circuit break- er. If the circuit breaker frequently trips, have the circuit inspected by a qualified electrician. Never use a larger circuit breaker than stated below.

Circuit Breaker

5 Amp, 1 Pole

Plug Type

The Model G9955 is supplied with a 5-15 plug, similar to Figure 1.

Figure 1. Typical grounding type 5-15 plug and

receptacle.

-6-

Grounding

In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least resistance to disperse electric current. This tool is equipped with a power cord that has a plug with an equipment-grounding prong. The outlet must be properly installed and grounded in accordance with all local codes and ordinances.

This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a two-pronged outlet! If the plug will not fit the outlet, have the proper outlet installed by a qualified electrician.

Extension Cords

•Make sure the cord is rated Standard Service (grade S) or better.

•The extension cord must also contain a ground wire and plug pin.

•Use at least a 16 gauge cord.

•DO NOT use a cord longer than 50 feet!

G9955 Bench Top Dual Fan Dust Filter