UNPACKING
When unpacking, check to make sure all that all the parts listed in the Parts List on page 13 are included. If any parts are missing or broken, please call Harbor Freight Tools at the phone number shown on the front cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE:
For additional information regarding the parts mentioned in
the following pages, refer to the Assembly Diagram on page 14.
To Attach The Four Casters To The Machine Base:
1.To attach the four Casters (39) to the Machine Base (41), place a Lock Washer (37) onto the threaded portion of each Caster. (See Assy. Diagram.)
2.Insert the threaded portion of each Caster (39) upward through the four mounting holes in the Machine Base (41). Then secure each Caster to the Machine Base, using four Lock Washers (37) and four Cap Nuts (36). (See Assy. Diagram.)
To Attach The Collector Bag To The Collector Body:
To attach the Collector Bag (23) to the Collector Body (27), slide the opening of the Collector Bag over the opening of the Collector Body. Then secure the Col- lector Bag to the Collector Body, using the Clamp (24). (See Assy. Diagram.)
To Attach An Inlet Hose To The Collector Body:
The Dust Collector is designed for use on one machine at a time, depending on the sawdust output of a particular machine. The Inlet Cover (25) of the Dust Collector can be connected to a machine using a 4” inside diameter flex hose and a clamp (available at most local hardware retail outlets). The Dust Collector can also be used as a portable vacuum to clean the shop area with a 4” inside diameter flex hose and vacuum attachment (neither included).
(See Figure E, next page.)
REV 03/06
SKU 94029 | For technical questions, please call | Page 10 |