Removing the Collector Bag
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
1.Disconnect the machine from the power source, unplug.
2.Remove the collector bag by pushing the ring of the collector bag upwards and pulling the bag out at an angle.
3.Empty the contents into an appropriate container.
4.Turn the bag inside out and clean.
5.Turn the bag outside in and insert into the housing.
WARNING
To reduce the risk of injury from moving parts, always keep inlet connected to a flexible hose. Failure to comply may result in serious injury!
Electrical Connections
WARNING
All electrical connections must be done by a
qualified electrician. All adjustments or
repairs must be done with the dust collector
disconnected from the power source,
unplugged. Failure to comply may result in
serious injury!
The
Before hooking up to the power source, make sure that the switch is in the off position.
Turning the Machine On & Off
Before hooking up to the power source, make sure that the switch is in the off position.
The dust collector can be turned on by flipping the start switch up. Flip the switch down to turn the dust collector off. There is a removable key that can be used to lock the machine in the “OFF” position.
Maintenance
WARNING
Never perform maintenance on this machine before turning switch off and removing plug from power source, unplug.
Failure to comply may cause serious injury!
Motor
Inspect the motor fan and blow out (with low pressure air hose) or vacuum any accumulation of foreign material in order to maintain normal motor ventilation.
Connecting the Dust collector to a Machine
Use the proper type hose to connect the dust collector to the machine being operated. Dryer vent hose is not acceptable for this purpose. Contact your nearest JET distributor for the full line of JET Dust Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET's dust hoods, hoses, clamps, fittings, and blast gates.
You can also purchase the JET “Dust Collection
Grounding the Dust Collection System
The dust collection system includes the dust collector and the hose, or duct work you use to connect the tools. The dust collector is grounded though the ground wire in the cord. The hose or duct work you use to connect the tool to the dust collector must also be grounded. To assist in grounding your system you can purchase the JET “Dust Collector Grounding Kit” stock # JW1053, and also the JET “Dust Collection
10