Snapper TP 100-400 manual Cart Assembly, Bracket B. Box

Page 5

Cart Assembly

NOTE: Sort out the hardware and arrange by size and t y p e . R e f e r t o f i g u r e 1 .

1.Install the wheel assemblies (A, figure 2) to the frame (B). Place the head of the swivel wheel on the end of the frame. Align the holes and place four 3/8- 16 x 1 hex bolts up through the frame and head of the swivel. Secure with four flat washers (13/32 I.D., 7/8 O.D.) and 3/S-16 locknuts.

3.Turn box upside down and install the frame to the U- bracket (figure 4). Align the two prong end (A) in the frame with the ends of the U-bracket and secure with two 112-13 x l-114 hex bolts and locknuts. DO NOT overtighten the locknuts, since the box pivots at this point for dumping.

A. Prong End

Figure 2

A. Wheel Assembly

6.Frame

2.Install the U-bracket (A, figure 3) to the bottom of the box (B). Place the three 5/16-20 x 3/4 slotted truss head bolts and three flat washers (1 l/32 I.D., 3/4 O.D.) through the inside of the box and the U-brack- et. Secure with three 5/16 lo&washers and nuts.

Figure 3

A.U-Bracket B. Box

NOTE: The latch handle (A, figure 5) is located on the right hand side on cart, Mfg. No. 169 1526 and on the left h a n d s i d e o n c a r t , M f g . N o . 1 6 9 2 0 8 5 .

4 . Turn box with frame upright and install the latch han- dle (A, figure 5) and two lii handles (B) as follows:

a. Latch Handle: Place one 5116-18 x 1 hex bolt with 5/16 spring washer through the inside of the box. Next place a 5116 flat washer over the bolt on the outside of the box, the latch handle, a 506 flat washer, a 506 spring washer and a 5/16 nut and

.- jam nut. Tighten the nuts so that when the latch handle turns the bolt and nut will not turn. (Be sure the cups of the spring washers are facing toward the box surface on both sides.)

b. Lii Handles: Install the two liti handles on the out- side of the box. Place two l/4-20 x l/2 slotted truss head b&s through the inside of the box and the Iii handle. Secure with two l/4 lo&washers and nuts.

A:‘,.Latr$ h?andle

B . LiiH&dle

5

b

Image 5
Contents MFG. no Wide Body Cart Collector‘in Decals Table of ContentsHitch and Tube Assembly Landlord11700 Series Description Hitch Assembly Sovereign/900 SeriesBracket B. Box Cart Assembly‘23!i4 Truss Connecting SleeveSupport Tubes B. Locking Tab Metal Loop Rubber Strap Dc+ockInstalled on turbo housing Discharge Tube InstallationBefore Operation MaintenanceOperation Ft./Lbs In./Lbs110’ 149.6 120