ASSEMBLY
ASSEMBLY TOOLS REQUIRED
* Phillips head screwdriver | * 12 mm wrench |
ASSEMBLY TIME ESTIMATE - 30 minutes to 1 hour
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
THIS MACHINE IS HEAVY. USE TWO OR MORE PEOPLE WHEN LIFTING.
CASTERS
1.Turn stand (A) upside down, as shown in Fig 1C.
2.Place 3/8” lockwasher on caster stud (B) and screw caster into threaded hole on the bottom of the stand. Repeat for other three casters.
3.Tighten caster by hand, then set with a thin 14mm wrench.
LEGS TO MOTOR/BLOWER
ASSEMBLY
1.Place motor/blower assembly with the motor (A) Fig. 2 down.
2.Place 5/16” flatwasher on knob (B).
3.Align holes on legs (C) with holes (D) in the motor/blower assembly. Legs should extend up. Insert knob through hole in the legs (C) and into threaded hole in the motor/blower assembly (D). Tighten knob securely.
4.Repeat steps for all knobs on both legs.
ATTACHING STAND TO LEGS ON MOTOR/BLOWER ASSEMBLY
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
Place all four stand posts (A) Fig. 3 into four legs (B) on motor/blower assembly. Make sure metal base plates
(D)are arranged over the large dust collection holes
A
B
Fig. 1C
B | C |
|
|
|
D
A
Fig. 2
D
A
B 
C
Fig. 3
9