3Com AP2750 quick start Installing the mounting bracket

Page 5

The figures below show the mounting bracket being mounted to a wall, and then a cable being routed through the large opening on the back of the mounting bracket.

Cradle

Installing the mounting bracket

Routing a cable

4Connect the Ethernet cable (and power cable, if applicable) to the port(s) on the front of the access point.

5Snap the access point onto the mounting bracket.

To install the locking bar, push the locking bar through the opening in the side of the mounting bracket until the hole on the locking bar is exposed. Insert a lock (not provided) through the hole on the locking bar, and then close the lock to secure it in place.

.11a .11g .100 .10

 

 

100

10

 

11g

 

.

11a

.

 

.

 

 

.

 

 

 

Inserting the locking bar

Securing the bar with a lock

5

Image 5
Contents About This Guide AP2750 Managed Access PointFeature Description 3Com AP2750 Managed Access Point FeaturesPreparing for Installation Observing Safety PrecautionsUnpacking the Access Point Attaching the Antennas Mounting the Access PointInstalling the mounting bracket Tabletop Mounting Connecting the Access Point to a SwitchTroubleshooting Checking the LED IndicatorsUSA-FEDERAL Communications Commission FCC Regulatory InformationUSA Radio Frequency Requirements Manufacturers Declaration of Conformity Interference HandbookCanada Industry Canada IC Safety Compliance NoticeIndustry Canada IC Emissions Compliance Statement Avis DE Conformité À LA Réglementation Dindustrie CanadaBepalingen van richtlijn 1999/5/EG Europe EU Declaration of ConformityRelevanten Festlegungen der Richtlinie 1999/5/EG. Wien Allowed Frequency Bands Allowed Channel Numbers Countries TPC Configuration Procedure Reduce Power to 25% and Recheck Link Rate
Related manuals
Manual 8 pages 39.68 Kb