ASSEMBLY
ASSEMBLING WHEEL
CASTERS
1.Remove the hex nut and lockwasher from each of the four wheel casters.
2.Place the dust collector on its side.
2.Insert bolt from wheel caster through the four holes
(A) Fig. 3 in the base of the dust collector.
3.Place a lockwasher (A) Fig. 4 onto each bolt.
4.Thread hex nut (B) Fig. 4 onto each of the four bolt heads and tighten securely.
A
Fig. 3
B
A
Fig. 4
ASSEMBLING OUTTAKE FLANGE
1.Align the holes in the outtake flange (A) Fig. 5 with the holes in the outtake flange gasket (B).
2.Insert a
3.Thread a 5/16” hex nut (B) onto the
4.Repeat this process for the three remaining bolts.
B
A
Fig. 5
B
A 
5
Fig. 6