FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
|
|
| THIS MACHINE IS HEAVY. USE TWO | A | |
|
|
| |||
OR MORE PEOPLE WHEN LIFTING. | |||||
| |||||
CASTERS
1.Turn stand (A) upside down, as shown in Fig 1C.
2.Place 3/8” lockwasher on caster stud (B) and screw caster into threaded hole on the bottom of the stand. Repeat for other three casters.
3.Tighten caster by hand, then set with a thin 14mm wrench.
B
Fig. 1C
LEGS TO MOTOR/BLOWER ASSEMBLY
1.Place motor/blower assembly with the motor (A) Fig. 2 down.
2.Place small 5/16” flatwasher on knob (B).
3.Align holes on legs (C) with holes (D) in the motor/blower assembly. Legs should extend up. Insert knob through hole in the legs (C) and into threaded hole in the motor/blower assembly (D). Tighten knob securely.
4.Repeat steps for all knobs on both legs.
BC
D
A
Fig. 2
ATTACHING STAND TO MOTOR/BLOWER ASSEMBLY
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
Place all four stand posts (A) Fig. 3 (three shown) into four legs (B) on motor/blower assembly. Make sure metal base plate (D) is arranged over the large dust collection hole (C).
D
A
B
C
Fig. 3
9