Woodstock W1779 owner manual Clearing Jammed Staples

Model W1779 18 Gauge Stapler Kit

To operate your stapler in bump fire mode, do these steps:

1.Push the trigger switch IN (Figure 7).

Figure 7. Trigger switch, bump fire

mode.

2.Pull and hold down the trigger.

3.Press the safety mechanism against your workpiece and raise it after the staple is driven.

4.Continue holding the trigger and repeat Step 3 to drive more staples.

Clearing Jammed

Staples

A jammed staple must be cleared before using the stapler again.

To clear a jammed staple from the discharge area, do these steps:

1.DISCONNECT STAPLER FROM THE AIR SUPPLY!

2.Pull back and latch the magazine.

3.Remove the staple stick from the magazine.

4.Loosen the cap screws shown in Figure 8, and remove the nose cover.

Nose Cover Cap Screw

Figure 8. Loosening cap screws on cover.

5.Remove the jammed staple with needle nose pliers.

6.Secure the safety cover with the cap screws removed in Step 4.

7.Throw the damaged staple away.

8.Inspect the staple stick. If it is bent or damaged, insert a new staple stick that only contains clean, undamaged staples. DO NOT use dirty or damaged staples!

9.Latch the magazine closed.

-10-