Set Up Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Loading the Staples

Figure 1

Push in and down to release the

Staple Channel Latch.

1.Push the End Clip forward and down to release the Staple Channel Latch. Pull out the Staple Channel-see Figure 1.

Figure 2

Standard U-Shaped Brad

staple staple

2.Load the staples or brad nails into the Staple Channel. Each of the fasteners is to be loaded into the Staple Channel with its sharp end facing the base of the Staple Channel-see Figure 2.

Staples are to be inserted into the center of the Staple Channel as shown in Figure 2. Brad nails are to be inserted on either side of the Staple Channel, as in Figure 2, but not placed in the center of the Staple Channel.

SKU 96755

For technical questions, please call 1-800-444-3353.

Page