Grizzly G6772 instruction manual Oiling Stapler, Cleaning Stapler

Oiling Stapler

The Model G6044/G6772 is considered an oil-less model. This means it features a teflon piston assembly that does not require oil to operate. However, periodic applications of oil will extend the useful life of the piston assembly.

Special oil has been included with you new Grizzly stapler. Periodically place one drop of oil in the stapler air inlet (as shown in Figure 6). After oiling, wipe off any excess oil near the stapler exhaust to avoid dust build-up. When the oil that was included with the stapler has been completely used, replace with Grizzly Model G2820 Pneumatic Tool Oil.

Another option to manual oiling would be to install a lubricator in your air compressor line. If your air compressor line already has a lubricator, then regular lubrication of your stapler will not be necessary. Just make sure there is always oil in the lubricator.

As mentioned before, the best option is to install a filter/lubricator/regulator unit such as the Grizzly Model H2333 in your air line.

Figure 6. Lubricating stapler via air inlet.

NOTICE

Too much oil in the stapler will ruin the O-rings!

Cleaning Stapler

Use a good solvent to clean the nose assembly of the stapler. Always be sure that the stapler is dry before using it again.

Do not allow dust, chips, sand, etc. into the air connectors or into the body of the sta- pler; this may result in leaks and damage to the stapler and the air couplings.

Never use gasoline or other flamma- ble liquids to clean this tool. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!

Always disconnect air from stapler whenever servicing! During mainte- nance, a stapler connected to air may fire accidentally, causing seri- ous personal injury!

G6044/G6772 16 Gauge Stapler Kit -9-