Desa 31400 operating instructions Unlocking Handle, Locking Handle, Loading Tool

UNLOCKING HANDLE Handle

1. Hold tool base and handle. Squeeze handle to release tension on handle lock. Slip handle lock off of handle (see Figure 1).

2. Release handle. Handle will spring free.

Handle

Handle Lock

Figure 1

LOCKING HANDLE

1.Hold tool firmly (see Figure 2).

2.Pull handle out to release, then push handle down (see Figure 2).

3.While holding handle down, slip handle lock up over handle (see Figure 3).

Handle

Handle Lock

Figure 2

Handle

Lock

Figure 3

LOADING TOOL

1.Lock handle (see Locking Handle).

2.Turn staplegun upside down. At rear of tool, squeeze latch on end of staple chan- nel (see Figure 4). Pull staple channel cover out of staple channel until it stops (see Figure 4).

3.Drop staples into staple channel. Make sure staple points are facing up (see Figure 4).

4.Slide staple channel cover back into staple channel until it locks into place.

Staples with

Points Facing Up

Staple Channel

Staple Channel Cover

Figure 4

www.desatech.com 2 110408