Jet Tools J-4400A, J-4401A, J-4300A, J-4301A, J-4202A, J-4200A-2 Table of contents

2.0Table of contents

Section				Page
1.0	Warranty and Service			2
2.0		Table of contents		3
3.0		Safety Warnings		4
4.0		Machine and Manual Overview		6
5.0		Specifications		7
6.0		Operating instructions		8
6.1			Belt sander	8
6.2			Adjusting the belt sander table	8
6.3			Using the indexing lock handle	8
6.4			Adjusting the belt sander arm	8
6.5			Adjusting disc sander table	9
6.6			Use of the Miter Gauge	9
7.0		Maintenance		10
7.1			Belt replacement	10
7.2			Track mechanism maintenance	10
7.3			Installing abrasive discs	11
7.4			Replacing the v-belt	11
8.0		Machine setup		13
8.1			Basic setup	13
8.2			Disc table angle adjustment	13
8.3			Disc table miter parallelism adjustment	13
8.4			Disc table gap adjustment	14
8.5			Belt table miter slot parallelism adjustment	14
8.6			Belt table angle adjustment	14
8.7			Adjusting or replacing the platen	15
9.0		Electrical connections		15
9.1			Single phase electrical hookup	16
9.2			Three phase electrical hookup	16
10.0		Troubleshooting		17
11.0 Replacement parts				18
11.1.1 Model J-4200A Belt and Disc Sander Assembly – Exploded View				18
11.1.2 Model J-4200A Belt and Disc Sander Assembly – Parts List				19
11.2.1 Model J-4300A Belt Sander Assembly – Exploded View				21
11.2.2 Model J-4300A Belt Sander Assembly – Parts List				22
11.3.1 Model J-4400A Disc Sander Assembly – Exploded View				24
11.3.2 Model J-4400A Disc Sander Assembly – Parts List				25
11.4.1 Base Assembly: All 1 Phase Models – Exploded View				26
11.4.2 Base Assembly: All 1 Phase Models – Parts List				27
11.5.1 Base Assembly: All 3 Phase Models – Exploded View				28
11.5.2 Base Assembly: All 3 Phase Models – Parts List				29
12.1		Electrical schematic – single phase		30
12.2		Electrical schematic – 3 phase		31

3