1
002588
1.Sharpening holder
1. Screwdriver
2. Chip cover
2
1
002593
First, loosen the two wing nuts on the holder and insert the blades (A) and (B), so that they contact the sides (C) and (D). Then tighten the wing nuts.
Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
|
|
|
| 1. Wing nut | |
1 |
|
|
| 2. | Blade (A) |
|
|
|
| 3. | Blade (B) |
|
|
|
| 4. | Side (D) |
| 2 |
| 5 | 5. | Side (C) |
|
|
|
| ||
|
|
|
|
| |
|
| 3 | 4 |
|
|
|
|
|
|
| |
002589 |
|
|
|
|
|
1
002594
1. Brush holder cap
Immerse the dressing stone in water for 2 or 3 minutes before sharpening. Hold the holder so that the both blades contact the dressing stone for simultaneous sharpening at the same angle.
002590
Replacing carbon brushes
1. Limit mark
1
001145
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes.
Use a screwdriver to remove the chip cover.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
•
•
•Sharpening holder assembly
•Blade gauge
•Socket wrench
NOTE:
•Some items in the list may be included in the tool package as standard accessories. They may differ from country to country.
6