READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:26556MCY
0798 | Page 1 of 2 |
INSTALLATION INSTRUCTIONS FOR ATTACHING AND OPERATING ProSpec™ TRACK LIGHTING FIXTURE. FOR JUNCTION BOX MOUNT.
CAUTION:
•Turn off power at fuse box before installing fixture.
•Fixture temperature is extremely high during operation. Use heat resident gloves or other heat resistant materials to protect hands when adjusting or handling the fixture during operation.
•Do not install fixture near combustible materials.
•Fixture is not for residential use.
•Electrical supply to fixture must be 120 volts. Electrical supply can be AC or DC.
•Do not mount fixture on a wall.
INSTRUCTIONS FOR ATTACHING FIXTURE TO
CANOPY is designed for a 4” octagon OUTLET BOX. FIXTURE can mount to different OUTLET BOXES as long as box mounting holes are on 3.5” centers and FIXTURE CANOPY covers box completely. Box mounting holes should be tapped with
1.Thread
2.WHILE SUPPORTING FIXTURE, MAKE CONNECTIONS: BLACK FIXTURE LEAD to HOT (BLACK) SUPPLY LEAD; WHITE FIXTURE LEAD to NEUTRAL (WHITE) SUPPLY LEAD. UNINSULATED FIXTURE WIRE is a ground and must be connected to GROUND TERMINAL or GROUND LEAD inside OUTLET BOX. Use WIRE NUTS (local hardware item). Push connections back into
OUTLET BOX.
3.Push CANOPY against ceiling passing STUDS through holes in CANOPY. Make sure wires are not pinched.
4.Thread 2 CAP SCREWS onto STUDS. Drive CAP SCREWS until CANOPY is tight against the ceiling.
CAUTION: CAP SCREWS must be completely threaded onto the STUDS.
NOTE: The proper LAMP should be installed into the FIXTURE prior to energizing. See instructions below.
WHITE WIRES (Neutral) 
GROUND WIRES
Fig. 1
BLACK WIRES (Hot)
CANOPY
CAP SCREW
SWITCH
LAMP TERMINAL
ACCESS KNOB
LAMPING & USING ACCESSORIES (Fig. 2)
The following lamps may be used in the FIXTURE: Fixture Cat. No. 26556M, WHCY, BKCY
Lamp | 12 Volt PAR 56 Screw Terminal |
| 120 to 240 Watt |
1.Holding SNOOT loosen ACCESS KNOB a few turns until SNOOT opens.
2.Screw SPADE TERMINALS into LAMP TERMINALS.
3.Align 3 LAMP BOSSES with 3 RING NOTCHES. Align LAMP SCREW TERMINALS with LAMP ALIGNMENT BRACKET. Push LAMP into FIXTURE until LAMP SPRINGS hold LAMP. NOTE: The 3 LAMP BOSSES must sit in the 3 RING NOTCHES
after the LAMP is installed.
4.Removing LAMP: Snap LAMP out of LAMPSPRINGS. Unscrew
LAMP TERMINALS.
LAMP ALIGNMENT BRACKET
LAMP SPRING
SNOOT
RING NOTCH
SPADE TERMINAL
LAMP BOSS
Fig. 2