INSTALLING BITS
See Figure 6.
•Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 3.
•Open or close chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of your drill slightly to keep the bit from falling out of the chuck jaws.
•Insert drill bit into chuck the full length of the jaws as shown in Figure 6.
DRILLBITCHUCK
RIGHT6
•Remove chuck key from storage. See Figure 4.
•Using only the chuck key provided, tighten the chuck jaws. Place chuck key in each of the three holes and tighten in a clockwise direction.
•Do not use a wrench to tighten or loosen the chuck jaws.
•Remove chuck key and return it to chuck key storage.
WARNING: Do not insertdrill bit intochuck jaws and tighten as shown in figure 7. This could cause drillbit to be thrown from drillresulting in possible serious personal injuryor damage to the chuck.
Fig. 7
REMOVING BITS
See Figure 6.
Lock the switch trigger by placing the direction of rotation selector in center position. See Figure 3.
Remove chuck key from storage. See Figure 4.
Loosen the chuck jaws using only the chuck key provided.
Do not use a wrench to tighten or loosen the chuck jaws.
Remove drill bit from chuck jaws,
Remove chuck key and return it to chuck key storage.