Powermatic 1285 operating instructions Unpacking, Contents of shipping container

Page 7

6.0Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

NOTE: The wrenches and knife setting gauge will be found inside the jointer stand.

6.1Contents of shipping container

1 Jointer

1Fence Assembly

1Dust Hood

1Knife Setting Gauge (for straight knife cutterhead only)

1 Hex Wrench, 10mm

1Combination Wrench, 10-12mm

2Push Blocks

1Owner's Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

7

Image 7

Contents Part No. M-0460216 PowermaticWarranty Period Warranty and ServiceTable of Contents Page Figure a Introduction Specifications Unpacking Contents of shipping containerFence Installation AssemblyTools need for assembly Grounding Instructions Switch ArmDust Hood Extension cords Voltage ConversionSetting Outfeed Table Height AdjustmentsDrive Belt Tension Page Replacing and Setting Knives Straight Cutterhead Setting Infeed Table Height Depth of CutPage Replacing Knife Inserts Helical Cutterhead To tilt fence backward Fence AdjustmentsTo check and adjust the 90-degree stop To tilt fence forwardCutter Guard Tension To check and adjust the 45-degree stopOperating Controls OperationRabbeting Hand PlacementEdge Jointing SurfacingBeveling Jointing Warped SurfacesJointing Short or Thin Work Direction of GrainLubrication MaintenanceCutterhead Repairs Knife Inserts Helical Cutterhead Whetting Knives Straight Cutterhead Probable Cause Remedy Troubleshooting the 1285 JointerOperating Problems TroubleMechanical and Electrical Problems Replacement Parts Optional AccessoriesIndex No. Part No Description Size Qty Stand Assembly Parts ListStand Assembly Exploded View Table Assembly Parts List Table Assembly Exploded View Motor Pulley Assembly Exploded View Motor Pulley Assembly Parts ListCutterhead Guard Assembly Exploded View Cutterhead Guard Assembly Parts ListPJ1285-KSGA Straight Cutterhead Assembly Parts ListStraight Cutterhead Assembly Exploded View Helical Cutterhead Assembly Parts List Helical Cutterhead Assembly Exploded View Fence Assembly Parts List Fence Assembly Exploded View Electrical connections for 1285 Jointer Electrical connections for 1-Phase onlyElectrical connections for 3-Phase only New Sanford Road LaVergne, Tennessee

Related manuals

Manual 44 pages 32.5 Kb