Operation

The GBC ProTrim 45 and ProTrim 63 were designed with ease of operation in mind.

The steps for proper operation are as follows:

1.) Move the cutter head all the way to the right or left side of the trimmer. (This is required because the paper clamp applies slight pressure to the print when the cutter head is not all the way to one side of the unit.)

2.) Insert the print to be trimmed.

3.) Adjust the edge guide as necessary to aid in squaring the print.

4.) Use the paper clamp as an aid to determine where the cut will be made in the print. Support the print with one hand; use your other hand to slide the cutter head across the trimmer to make the cut.

5.) Remove the trimmed pieces from the waste curtain as necessary.