Operating the Impact Wrench, Assembly

The battery pack and charger heat during charging. Place the charger on a flat, non-flammable surface away from flammable materials with at least four inches of clearance to allow proper air circulation around the charger and battery pack.

When the battery pack requires recharging, a 1 hour charge allows the tool to operate at full power. A charging indicator light on the charger will illuminate to show that charging is taking place.

CHARGING BATTERY PACK USING ONE HOUR CHARGER #690507

INSTALLING / REMOVING SOCKET ON THE ANVIL

When removing the socket or bit from the tool, avoid contact with skin and use proper protective gloves when grasping the socket, bit or accessory. Accessories may be hot after prolonged use.

CHARGE BATTERY PACK:

1.Plug the charger into the nearest 120 volt electrical outlet. The step of the battery has positive and negative terminal markings on it. Align the markings with the identical markings on the top of the charger base. Insert the battery pack into base. Pack will not insert properly if reversed.

2.Make sure the trigger on the Impact Wrench is in the “OFF” position and remove the battery pack from the Cordless Impact Wrench.

BATTERY PACK

BATTERY

CHARGER

When installing a socket, align the holes in the side of the socket with the dent pin. Press the socket on until the dent pin engages in the hole. To remove a socket, depress the dent pin through the hole using a small pointed object and pull the socket off.

OPERATING THE IMPACT WRENCH

Never tape the trigger switch down to provide continuous

3.	If, when first inserting the battery pack, the red “ON” button does not light up,
	press the “SET” button on the charger. When the battery is charging, the red
	light is “ON”.
4.	After approximately one hour of charging, the red indicator light should go

high speed. The tool may fail under such conditions causing fire or personal injury.

VARIABLE SPEED TRIGGER SWITCH

“OFF” and the green light should come “ON”. The green light indicates that the

battery is fully charged.

5. When fully charged, reattach battery pack onto Cordless Impact Wrench, mak-

ing certain latches fasten securely. Cordless Impact Wrench will not operate

properly if the battery pack is not seated properly.

ASSEMBLY

Be aware that this tool is always in an operating condi- tion because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.

THIS TOOL IS CONTROLLED BY A TRIGGER SWITCH:

•The speed of the Cordless Impact Wrench depends on the amount of pressure you put on the trigger.

•The more pressure you apply, the faster the Cordless Impact Wrench will go.

•Release the pressure and the Cordless Impact Wrench will slow down.

TRIGGER SWITCH