REMOVING / ATTACHING BATTERY PACK
CHARGING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release buttons on either side of the Impact Wrench to release the battery pack.
2. Pull battery pack free of Impact Wrench.
ATTACH BATTERY PACK:
1. Align the raised portion of the bat- tery pack with the groove in the battery compartment of the Impact Wrench.
2. Press the battery pack into place. | RELEASE | |
Make sure the latches are securely | ||
BUTTON | ||
fastened. Do not use the Impact |
|
CHARGE BATTERY PACK:
1.Make sure the trigger on the Cordless Impact
Wrench is in the “OFF” position and remove the battery pack from the Impact Wrench.
2. Insert the battery pack into the charger. Be sure that the battery pack is fully seated in the charg- er. Do not force.
3.Plug the charger into the nearest 120 volt, electrical outlet. The indicator light will come “ON”.
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
BATTERY
CHARGER
Wrench if the battery pack is not |
seated properly. |
CHARGER
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
When the battery pack requires recharging, a
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your Cordless Impact Wrench continuously, the batteries in your bat- tery pack will become hot. You should let a hot battery pack cool down for approx- imately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, the red light on the charger will flash. When the battery pack cools down, the red light will glow continuously.
This will occur when continuous use of your Cordless Impact Wrench causes the battery pack to become hot. It does not occur under normal circumstances.
ASSEMBLY
Be aware that this tool is always in an operating condi- tion because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.
12