REMOVING/ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release buttons on either side of the Cordless Drill to release the battery pack.
When the battery pack requires recharging, a
2. Pull battery pack free of Cordless Drill.
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack with the groove in the battery compartment of the Cordless Drill.
2. Press the battery pack into place. Make sure
RELEASE
the latches are securely fastened. Do not use BUTTON the Cordless Drill if the battery pack is not
seated properly.
CHARGER
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger on the Cordless Drill is in the “OFF” position and remove the battery
pack from the Cordless Drill.
2. Plug 120V AC Adapter |
|
into household outlet |
|
and into side of battery |
|
charger. Insert battery |
|
pack into battery charger. |
|
When the battery is placed in | BATTERY |
the charger, the red LED | |
indicator light will remain on. | CHARGER |
|
BATTERY PACK
120V AC
ADAPTER
LED LIGHT
Before using battery charger, please read carefully all instructions and cautionary markings on battery charger, battery pack and product using battery.
The charger will not automatically turn “OFF” when the battery pack is fully charged. The charging indicator light will remain “ON” until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as listed in this manual. Do not substitute any other charger. Use only Alltrade approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
3.When fully charged, reattach battery pack onto Cordless Drill, making certain latches fasten securely. Cordless Drill will not operate properly if the battery pack is not seated properly.
ASSEMBLY
Be aware that this tool is always in an operating condition because it does not have to be plugged into an electrical outlet. Always turn the switch “OFF” and remove the battery pack before changing bits.
11 | 12 |