Chicago Electric 92472 INSPECTION, MAINTENANCE, and Cleaning, Do not use damaged equipment

Page 9

2.If necessary, adjust the Forward/Reverse Lever (37). (See Figure A.)

3.Whenever possible, secure the workpiece in place, using a vise or clamps (not included).

4.Insert the fully charged Battery (40) into the Handle of the Impact Driver.

(See Figure B.)

5.Make sure to hold the Impact Driver firmly with both hands, as torque from the Motor will cause the tool to twist.

6.Insert the Screwdriver (39) into the screw, or insert the Socket (42, 43, 44, 45) onto a bolt. Then, turn on the Impact Driver, using the Trigger (34). (See Figure A.)

7.When finished using the Impact Driver, release the Trigger (34) to stop the tool. Make sure to torque the bolt with a torque wrench (not included) according to the manufacturer’s recommended torque setting. Then, remove the Battery (40) and Screwdriver, or Socket, from the Impact Driver. (See Figure A.)

8.Make sure to store the Impact Driver and its accessories in the Carrying Case 47), and place the Carrying Case in a safe, dry, clean location out of reach of children.

INSPECTION, MAINTENANCE, AND CLEANING

1.WARNING! Always turn the Trigger (34) to its “OFF” position, remove the Battery (40), and unplug the Charger (46) from its electrical outlet before performing any inspection, maintenance, or cleaning.

2.Before each use: Inspect the general condition of the Impact Driver. Check for misalignment or binding of moving parts, cracked or broken parts, leaking Battery, damaged Charger wiring, chipped or broken Drill Bit/Sockets, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.

Do not use damaged equipment.

3.Battery precautions: Never burn Batteries, as they can explode in a fire. Do not charge leaking Batteries. Only a qualified service technician should perform maintenance on the Battery. Contact local solid waste authorities for instructions on correct disposal or recycling of the Battery.

4.Daily: With a soft brush or cloth, remove all dirt and debris from the Impact Driver. Do not immerse the Impact Driver in any liquids.

SKU 92472

For technical questions, please call 1-800-444-3353

PAGE 9

Image 9
Contents Volt Impact Driver KIT HEX Drive For technical questions, or replacement parts, please callGeneral Safety Rules Product SpecificationsUnpacking Save this ManualPersonal Safety Electrical SafetySpecific Safety Rules ServiceTool USE and Care SKU For technical questions, please call Product Features See Figure a To Charge the Impact DriverSide View Front View Operating InstructionsDo not use damaged equipment INSPECTION, MAINTENANCE, and CleaningPlease Read the Following Carefully Parts ListAssembly Diagram