ETA Systems ETA-S20RT specifications Rear Panel Features

Page 8

ETA-S20RT

AC Distribution & Suppressor Unit

REAR PANEL FEATURES

5

4

3

2

1

1. AC Mains Input

Connect the 14 Gauge 9' (3m) power cord to a 20A 120VAC outlet to provide power to the ETA-S20RT.

2. AC Power Outlets

These six outlets are “Live” when the front panel power switch is activated. The two Unswitched Outlets are always live if the power cord is connected to 120VAC.

3. XLR Light Socket

A 12VDC XLR light socket provides power for the optional AP-GNL18 light.

4. Light Socket Power Switch

Two-position switch to power On/Off the XLR light socket.

5. Remote Activation

There are two methods to remotely activate the ETA-S20RT:

A. External Switch - The Ext SW terminals are connected to a latching type dry contact closure to activate the ETA-S20RT. Note: The Remote Bypass switch must be shorted for Remote Activation. This feature can be used for Emergency Power Down (EPD), when tied into a normally closed latching contact closure (e.g. Fire Panel).

B.DC Voltage - When you apply 5V - 24VDC to the Ext SW terminals the unit will activate. See “Remote Activation Drawings” for details.

The terminals marked “+12V” and “GND” can be connected to a remote panel LED (not included) to indicate function when remotely activated.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

– 8 –

ETAsys.com

Specifications are subject to change without notice.

Image 8
Contents ETA-S20RT ETAsys.comTable of Contents Important Safety Instructions ETA-S20RT Introduction KEY Features ApplicationsFront Panel Features Rear Panel Features Installation Specifications Technical DataFront Panel Rear PanelETA-S20RT Limited Warranty Service