Maintenance
1.Make sure your Impact Wrench is disconnected from the air hose before attempting any maintenance.
2.Wipe the Impact Wrench down with a lint free cloth after each use.
3.Make sure the Anvil (6) is clear of dirt or debris. If possible, spray it with compressed air before each use.
4.If you do not use an inline oiler/filter system, lubricate the tool daily by holding it so that the Air Inlet (31) is facing up. Squeeze the Trigger (20), and place one or two drops of oil into the Air Inlet (31). Squeezing the Trigger (20) allows the oil to circulate in the motor.
FIGURE 1 |
|
|
|
| Anvil (6) |
|
|
| |||
|
|
| Grease Fitting (2) | ||
|
|
| |||
|
|
|
|
| Trigger (20) |
Regulator
Knob (45)
Air Inlet (31)
Reverse | Forward |
FIGURE 2
Turn the Regulator Knob (45) for more air flow and more power.
Turn the Knob to the right for Forward; turn left for Reverse.
SKU 94802 | For technical questions, please call | Page |