3Using a straightedge as a guide and the set screws for leveling control, position the extension wings even with the table, then fully tighten the hex bolts.
NOTE: Be aware that the bed rollers will give you a false reading with your straightedge if they are raised above the table. Move them down or work around them when leveling the extension wings.
Hand Wheel
You will need:
Hand wheel, Hand wheel Bushing, Hand wheel Handle, Hex Nut, Flat Washer
To install the Hand wheel:
1Place the bushing on the Hand wheel shaft.
2 Insert the key into the shaft keyway.
3 Screw the handle into the Hand wheel.
4Place the Hand wheel on the shaft and secure it with the hex nut and flat washer, as shown in Figure 7.
Dust Hood
IMPORTANT: If you are not using a dust collection system, do not use plastic dust
! hood to direct chips. We reccomend to always use a dust collector when operating this planer.
You will need:
Dust Hood, 3 x Hex Bolts, 3 x Cap Screws, 6 x Flat Washers, 3 x Hex Nuts, 6 x Flange Bolts
To install the dust hood:
1Attach the dust hood to the top of the planer with the hex bolts, flat washers, and hex nuts as shown in Figure 8. NOTE: You will need to reach into the dust hood to get access for fastening the nuts.
2Attach the bottom of the dust hood to the planer with the cap screws.
3If you have a dust collector, attach it to the dust hood now. NOTE: To maximize work results and minimize clogging, chip out, etc., use a dust collector with your planer.
Figure 6
Figure 7
Figure 8
© 2006 Pioneer Supply International | 13 |