Delta TP300 instruction manual Assembly, Raising and Lowering Handle, Lowering Extension Tables

Page 8

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

RAISING AND LOWERING HANDLE

1.Assemble raising and lowering handle (A) Fig. 4, to shaft (B) and fasten in place with M5x20mm screw (C). NOTE: Make certain the flats of the handle and flat on shaft are aligned with each other.

A

B

C

Fig. 4

2. Flip handle (A) upward as shown in Fig. 5.

A

Fig. 5

LOWERING

EXTENSION TABLES

The infeed and outfeed extension tables (A) Fig. 6, are shipped attached to the machine in the raised position. Lower the tables (A) on both sides of the planer as shown in Fig. 6. The top surface of extension tables should be level with the planer table. To check and adjust if necessary, refer to section “LEVELING EXTENSION TABLES” of this manual.

A

Fig. 6

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Portable Planer Safety Guidelines Definitions Stay ALERT, Watch What YOU are Doing Additional Safety Rules for Planers Refer to them often Use them to instruct othersPower Connections Unpacking and Cleaning Extension CordsPlaner Parts Lowering Extension Tables AssemblyRaising and Lowering Handle Fastening Planer to Supporting Surface Chip DeflectorOperating Controls and Adjustments Locking Switch OFF PositionRaising and Lowering Head Assembly Starting Stopping PlanerLeveling Extension Tables Storing the Power CordAdjusting Knives Replacing and Resetting Knives Operation Lifting StrapsLubrication MaintenanceBrush Inspection Replacement Page Accessories PARTS, Service or Warranty AssistanceCanadian PORTER-CABLE Delta Service Centers
Top Page Image Contents