c. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
Additional safety rules for electric planers
•Fully unwind cable drum extensions to avoid potential overheating.
•When an extension cable is required, you must ensure that it has the right ampere rating for your power tool and is in safe electrical condition.
•Ensure your mains supply voltage is the same as your tool rating plate voltage.
•After long working periods, external metal parts and accessories could be hot.
•If possible, always use clamps or a vice to hold your work.
•Always switch off before you put the planer down.
•Do not force the planer: let the tool do the work at a reasonable speed. Overloading will occur if too much pressure is applied and the motor slows resulting in inefficient planing and possible damage to the planer motor.
•Always use a dust extraction system where possible.
•Rags, cloths, cord, string and the like should never be left around the work area.
•Remove all nails, screws and other objects from the workpiece. You can damage the blade and the tool by cutting into a nail or other foreign object. It can also present a safety hazard.
•Handle the blades very carefully.
•Be sure that the blade installation bolts are securely tightened before operation.
•Always wear eye and ear protection and use a dust mask.
•Hold the tool firmly with both hands.
•Keep hands away from rotating parts.
•Before using the tool on an actual workpiece, switch on and let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade.
•Make sure that a blade is not in contact with the workpiece when you switch the machine on.
•Wait until the blades attain full speed before cutting.
•Operate the tool at least 200mm away from your face and body.
•Always switch off and wait until the blades have come to a complete standstill before attempting any adjustments.
5