Grizzly G1033Z manual Scale Adjustment, Anti-Kickback Fingers

Page 24

Scale Adjustment

 

Anti-Kickback Fingers

 

 

 

 

 

 

The scale can be adjusted for accuracy. The machine will need to be run to make proper adjustments. Follow the directions on the follow- ing page for a test run before attempting to make adjustments. Once youÕve successfully tested the planer:

1.Set the table to the approximate thickness of your test lumber. Measure the lumber with calipers to determine its exact thick- ness.

2.Move the table to 1Ú16'' under the thickness of your lumber and feed your test board through the planer.

3.Turn the handwheel one full rotation and run the board through once more. Turn the board over and repeat.

4.Re-measure the board and compare your results with the scale. If there is a discrep- ancy, loosen the Allen¨ head bolts and adjust to match your findings. See Figure 23.

Figure 23. Cutterhead height scale.

The Model G1033 provides an anti-kickback sys- tem as a safety feature. The anti-kickback fingers hang from a rod suspended across the cutter- head casting. The anti-kickback fingers should be inspected regularly. Check the fingers to ensure that they swing freely and easily. See Figure 24. Do not apply oil or other lubricants to the anti- kickback fingers. Oil or grease will attract dust, restricting the free movement of the fingers.

Proper operation of the anti-kickback fin- gers are essential for the safe operation of this machine. Failure to ensure that they are working properly could result in serious operator injury.

Figure 24. Anti-kickback fingers.

-20-

G1033 20" Planer

Image 24
Contents Manual Insert 20 5 HP PlanerG1033Z Replacement Parts Planer Page Table Of Contents Safety Safety Instructions For Power ToolsAMP Rating Additional Safety Instructions For Planers Fusing Circuit Requirements220V Operation Grounding Extension CordsIntroduction CommentaryUnpacking Parts InventoryClean Up Site ConsiderationsAssembly OverviewExtension Rollers Hand WheelDust Hood Switch Attaching switchKnife Setting Jig Knife setting jigAdjustments Chain Adjustment Table AdjustmentMicro-adjustment screws G1033 20 Planer Chain DriveBed Rollers Knife Adjustment Knife InspectionRoller Adjustment Feed Roller SpeedSpring Tension Tension screw locations G1033 20 PlanerChipbreaker Pressure Bar Static Chain Adjuster Chip DeflectorScale Adjustment Anti-Kickback FingersOperations Test Run Operational TipsWood Characteristics Maintenance GeneralKnife Sharpening Lubrication Feed roller lubrication points G1033 20 PlanerBelt Tension Belt Alignment Closure Machine Data Sheet Troubleshooting Symptom Possible Cause Corrective Action107 108 8894 109 Headcasting Middle Table 297 2810 Stand Gear BOX PSB18M G1033 20 Planer G1033 Wiring Diagram -Taian Type Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC