Rollercase 1/16”. The manual elevation Handle is located on the top/right side of the Planer. (See Figure H.)
MANUAL ELEVATION HANDLE
(5)
FIGURE H
6.Depth of Cut Gauge (131) and Scale (134): A Depth of Cut Gauge is attached to the front of the Rollercase (136). The Pointer on the Depth of Cut Gauge displays the depth of cut per pass when the workpiece is positioned below the Gauge. Turning the Manual Elevation Handle (5) moves the Rollercase down and the Pointer shows depth of cut up to 7/64”. The Scale with Pointer indicates the finished size of the workpiece.
Recommended Maximum Depth of Cut: Hard/Softwood up to 8” wide = 7/64” Hard/Softwood 8” to 15” wide = 1/16”
(See Figure I.)
DEPTH OF CUT GAUGE & SCALE (131, 134)
FIGURE I
7.Thickness Preset Control Knob (279): A six position Thickness Preset Control Knob is located on the lower/right side of the Planer. This feature allows for quick production of identically sized workpieces. The six settings provided are: 1/8”, 1/4”, 1/2”, 3/4”, 1”, and
Example: To plane a 2” thick workpiece down to 1-1/4”:
A.Raise or lower the Rollercase (136) until it is just above the workpiece.
B.Position the workpiece on the Planer Extension Table (223) below the Rollercase.
C.Turn the Thickness Preset Control Knob (279) until
D.The Planer is now set to stop the Rollercase (136) when the workpiece
REV 07e
SKU 95518 | For technical questions, please call | PAGE 12 |