1.The Fence has a scale indicating degrees from 90 to 135.
2.The Fence can also be set to 0.
Functions
Cutting Depth Adjustment
1.Face the Knob (83) and turn it clock- wise to decrease depth.
2.To increase cutting depth, turn the Knob (83) counterclockwise.
3.DO NOT adjust the cutting depth so that it exceeds 1/8”.
Push Block
The Push Block (89) has a screw by which the Push Block can be at- tached to your work piece. Line up screw and turn knob until Push Block is secured in place.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
Replacing Blades
1.Make certain to check tightness of the Blade Hex Bolts prior to each use.
2.Release Stop Block and remove Fence.
3.Use Hex Wrench (not included) to loosen Hex Bolts and remove worn Blades (58). Replace with new Blades.
4.Set Scale to zero. Using a straight edge, lay it across Blades. At point that Blade touches straight edge, the Blade should evenly touch the straight edge and be square the Planer face.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage.
SKU 65673 | For technical questions, please call | Page 10 |