EMC compliance, FCC Intentional Radiator Certification

EMC compliance

FCC Intentional Radiator Certification

RFID Reader Model 810

FCC ID: DGFTTS810

IC: 458A-TTS810

This equipment contains an intentional radiator approved by the FCC and Industry Canada. This device complies with both FCC Part 15 and Canadian ICES-003 rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation.

Note: This equipment has been tested and found to comply with the limits for a Class A device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

NO MODIFICATION: Modifications to this device shall not be made without the written consent of the 3M Company. Unauthorized modifications may void the authority granted under Federal Communications Commission rules and Industry Canada rules permitting the operation of this device.

This device has been designed to operate only with the following antennas. Antennas not included in this list or having a gain greater than the listed antennas are strictly prohibited for use with this device and may void the authority granted under FCC and Industry Canada Rules permitting the operation of this device.

•78–8129–2159–7, 12–inch Pad antenna

•78–8129–2122–5, 8–inch Pad antenna

•78–8126–8102–7, V-antenna

•78–8129–2618–2, L-antenna

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communications. Contact your 3M representative as to which antenna is best for your application.

EMC compliance Europe

This equipment complies with the requirements of the R&TTE and EMC directives. See appropriate system owner’s manual.