Parkside PMGS 12 manual General safety advice for electrical power tools, Workplace safety

Page 7

General safety advice for electrical power tools

MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTER- IES (WITHOUT A MAINS LEAD).

1. Workplace safety

a)Keep your working area clean and well lit. Untidy or poorly lit working areas can lead to accidents.

b)Do not work with the device

in potentially explosive envi- ronments in which there are

inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes.

c)Keep children and other peo-

ple away while you are op- erating the electrical tool.

Distractions can cause you to lose control of the device.

2. Electrical safety

To avoid danger to life from electric shock:

a)The mains plug on the device must match the mains socket. The plug must not be modified in any way. Do not use an adapter plug with devices fitted with a protective earth. Unmodified plugs and matching sockets reduce the risk of electric shock.

b)Avoid touching earthed surfaces such as pipes, radiators, ovens and refrig- erators with any part of your body.

There is an increased risk of electric shock if your body is earthed.

c)Keep the device away from rain or moisture. Water entering an electrical device increases the risk of electric shock.

d)Do not use the mains lead for

any purpose for which it was not intended, e.g. to carry the device, to hang up the device or to pull the mains plug out of the mains socket.

8 GB/IE/CY

Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. Damaged or tangled mains leads in- crease the risk of electric shock.

e)When working outdoors with an elec- trical power tool always use extension cables that are also approved for use outdoors. The use of an extension cable suit- able for outdoor use reduces the risk of electric shock.

f)Use a residual current device (RCD) for protection if operating the electrical power tool in a moist environment is unavoidable. The use of an RCD reduces the risk of electric shock.

3. Personal safety

a)Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One mo- ment of carelessness when using the device can lead to serious injury.

b)Wear personal protective equipment and always wear safety glasses. The wearing of

personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of elec- trical power tool used and work undertaken, reduces the risk of injury.

c)Avoid unintentional operation of the device. Check that the electrical power tool is switched off before you connect it to the mains, pick it up or carry it. Accidents can happen if you carry the device with your finger on the ON / OFF switch or with the device switched on.

d)Remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury.

e)Avoid placing your body in an unnat- ural position. Keep proper footing and balance at all times. By doing this

Image 7
Contents PMGS  Page Page Table of contents Modelling and engraving set Features and equipmentIntroduction  / AhTechnical information Included itemsPersonal safety General safety advice for electrical power toolsWorkplace safety Electrical safetyAvoid contact with moving sanding or grinding tools Careful handling and use of electrical power toolsInserting or replacing a tool / collet Switching on and off / Setting the speed rangeTips and tricks Advice on working with materials / Tools / Speed rangesDo not dispose of electric tools in the household waste Maintenance and cleaningService Warranty DisposalManufacturer’s Declaration of Conformity / Manufacturer Manufacturer’s Declaration of Conformity / Manufacturer