Siemens TM, AS 488 manual Update by Programming Device PG740

Product Information	November, 2001
AS 488/TM	M02.02

To check the update procedure, start the new ASBEDIEN and select the AS status screen ( BT,STAT:@; ). In addition to the start-up message, the system version ( M01.08 ) is displayed.

Note:	If there is already a version M02.01 on the memory card, you can use the
	files from directory C:\UPGRADE\AS_SW.202\M02.02 instead of the files
	from C:\UPGRADE\Update_M.108 for the online update (additionally to the
	files from C:\UPGRADE\AS_SW.202). From this results a version M02.02!
Attention:	The data transfer was only successful if the command COPY_TM ends
	without error messages, and without any manual intervention (e.g.
	termination with ESC). In the case of errors, the copy procedure must be
	repeated.

If problems occur during the data transfer (frequent terminations), we recommend the following procedure:

•If the first file (IBS_BEDI.386) was transferred without errors, the AS can be rebooted with the new emergency utility disk (press MRES during switch-on). Together with the new ASBEDIEN V1.08 or V2.00, an error free transfer can be expected.

•Before the next RESET, the files IBS_BEDI.386 and STARTER.386 must be successfully transferred.

2.3.2Update by Programming Device PG740

Before starting the UPDATE activities (pulling the memory card), please ensure that a current backup of the customer's system and any files that are to be modified exists. This will allow the previous software version to be restored in the even of unforeseen circumstances.

Stop your AS running (e.g. with STO) and then switch the AS off before pulling the memory card!

Copy the files listed under 2.3.1 from the upgrade/update directories into a new directory having the 'name' of your PG740.

For the update, insert the memory card into the MEM-CARD slot of the PG740. Now copy all files from the directory 'name' onto the memory card (either using the file manager or explorer, or using a DOS box):

COPY name\*.* E: /y

Now perform the following two steps:

1)Plug the upgraded memory card of the AS back into the allocated AS 488/TM and initiate a reboot of the AS 488/TM (power on).

2)Install the new terminal program ASBEDIEN V1.08 to your PC from the second diskette (IBS tools) included with your delivery.

To check the update procedure, start the new ASBEDIEN and select the AS status screen ( BT,STAT:@; ). In addition to the start-up message, the system version ( M01.08 ) is displayed.

Copyright © SIEMENS AG 1996-2001. All Rights Reserved. S79220-A0977-A-10-7637 Page 10 of 18