Miller Electric OM-1102 manual Safety Precautions and Signal Words, Specifications, General

SECTION 1 – SAFETY PRECAUTIONS AND SIGNAL WORDS

1-1. GENERAL INFORMATION AND SAFETY

A. General

Information presented in this manual and on various la- bels, tags, and plates on the unit pertains to equipment design, installation, operation, maintenance, and troubleshooting which should be read, understood, and followed for the safe and effective use of this equipment.

B. Safety

The installation, operation, maintenance, and trouble- shooting of arc welding equipment requires practices and procedures which ensure personal safety and the safety of others. Therefore, this equipment is to be in- stalled, operated, and maintained only by qualified per- sons in accordance with this manual and all safety pre- cautions in the welding power source Owner’s Manual.

1-2. SAFETY ALERT SYMBOL AND SIGNAL WORDS

The following safety alert symbol and signal words are used throughout this manual to call attention to and identify different levels of hazard and special instruc- tions.

This safety alert symbol is used with the signal words WARNING and CAUTION to call atten- tion to the safety statements.

WARNING statements identify procedures or practices which must be followed to avoid seri- ous personal injury or loss of life.

CAUTION statements identify procedures or practices which must be followed to avoid minor personal injury or damage to this equipment.

IMPORTANT statements identify special instructions necessary for the most efficient operation of this equip- ment.

SECTION 2 – SPECIFICATIONS

Gas Cylinder Support Bracket Located

Here (SWINGPAK-12 Models Only)

Coolant System	Flux
(Mounted Onto
SWINGPAK	Tank
Locker)

	Welding
Boom	Power
	Source
Support	L
Base

Resistance

Grid

(Mounted Onto

SWINGPAK

Locker)

K

G

H

J

**65 in. (1651 mm)

Swingpak-12

FRONT

*66-7/8 in. (1699 mm) Swingpak-16 **79 in. (2007 mm) Swingpak-16

*50-7/8 in.

(1292 mm) Swingpak-12

		C
		F
	B	E
A		D		Inches	Millimeters
			A	28	711
			B	30	762
			C	31	787
			D	32-3/4	831
			E	37	940
			F	39	991
			G	14-1/2	368
			H	16-3/4	415
			J	20	508
			K	12-3/8	314
		S-0458-A	L	24-1/16	611

Figure 2-1. Overall Dimensions, Mounting Hole Layout, And Component Locations

OM-1102 Page 1