Miller Electric RCT-224 Trailer manual Assembly, Preparing Unit For Kit Installation, As shown

Page 8

SECTION 3 − ASSEMBLY

NOTE

This trailer is not compatible with equipment made prior to Serial No. LB033208.

All directions are given as facing the towing vehicle. The word “front” means the hitch end of the trailer.

3-1. Preparing Unit For Kit Installation

Y Stop engine, and let cool.

Disconnect battery negative (−) cable.

Y Do not weld on base. Weld- ing on base can cause fuel tank fire or explosion. Weld only on the four mounting brackets or bolt unit down.

. Go to Section 3-2if mounting

1	brackets are already installed
1	as shown.
1	Mounting Bracket
2	3/8-16 x 1 in Screws
	(Supplied)

Remove hardware securing the rear mounting brackets to the base.

	Reverse rear brackets and reattach
	to base with original hardware.
	Tighten hardware to 30 ft lb (41
	N.m).
	2
Tools Needed:
9/16 in	Ref. 190 250-A / Ref. 802 729

OM-6611 Page 6

Image 8

Contents OM-6611 DescriptionFrom Miller to You Overloading can cause serious injury or equipment damage Trailer Towing Safety PrecautionsTrailer Towing can be hazardous Unexpected Tilting of Trailer can cause injury and damage Incorrectly Working Lights can cause accidentsPRE-TOWING Checklist Symbol Usage Assembly HazardsFalling Unit can cause injury Tilting of Trailer can cause injuryOverall Dimensions − SpecificationsTrailer Specifications − Assembly Preparing Unit For Kit InstallationGo to -2if mounting As shownMounting Wheels And Brackets On Axles Mounting Axle On FrameInstalling Hitch And Safety Chains Lunette Eye Hitch Optional Ball HitchInstalling Taillight And Sidelight Wiring Yellow leads. Discard green and yellow leadsInstalling Wiring Harness Tab Connectors Mounting Welding Generator Tightening Trailer Hardware Mounting Fenders Use hardware in green bag to install lights To connect sidelightsMaintenance Torquing Wheel Bearings OM-6611 − Parts List Hardware is commonOptional Page Service SupportOwner’s Record Miller Electric Mfg. Co