DM 2610958467
Sanding/Grinding Guide Attachment Model A576
! WARNING Read and understand the manual for the use of the tool with this accessory.
SAVE THESE INSTRUCTIONS
P.O. Box 1468
Racine, Wisconsin 53401
http://www.dremel.com
| For use with 1/2” or less sand- | |
! WARNING | ||
ing and grinding stone acces- | ||
sories only. | ||
|
Attachment for use with Dremel Rotary Tool Models 100, 200, 300, 400, 4000, 770, 800, 275, 285, 395, 398.
The guide comes completely assembled and ready to use for sanding and grinding applica- tions up to ½” ( 13 mm) thick.
Router bits are not allowed for use with the Sanding/Grinding
Guide attachment.
Sanding/Grinding Guide Attachment
Installation instructions:
Step 1: Remove the housing cap A from the end of the tool and set housing cap aside. The original housing cap must be reinstalled when this attachment is not used (Fig. 1).
Step 2 & 3: Loosen the collet nut and place your
accessory in and tighten. Note: The attachment is for ½” diameter accessories or smaller.
Please refer to the owner's manual for proper collet nut assembly instructions and accessory operation instructions.
When inserting a bit into your ! CAUTION Dremel Rotary Tool be sure
that the bit is securely inserted into the collet. Al- ways use the wrench to tighen the collet nut to prevent the bit from loosening within the collet. Do not use the Dremel Chuck.
Step 4: Thread the attachment B onto the threaded portion of the housing collar C (Fig. 2).
Step 5: Adjust the attachment B to the desired depth by loosening the wing knob D (Fig. 3).
Using the Sanding/Grinding Guide
Attachment
The guide has a 90 and 45 degree bevel for var- ious sanding applications. The tool with the guide attached can be taken to a secure work piece or can be stationary in the Dremel Multi- Vise.
Installation instructions to Dremel
Multi-Vise:
The tool with the guide attached can be taken to a secure workpiece or can be stationary in the Dremel
Step 1: Set up Dremel
Step 2: Place tool with accessory secure through the tool holder F (Fig. 4).
Step 3: Hold the Sanding/Grinding Guide B firm and thread onto front end of tool until tightly secure (Fig. 4).
Step 4: The guide can be adjusted from the 90 degree side to the 45 degree side by loosening the wing nut D and sliding the attachment B off the cylinder E (Fig. 5).
Step 5: Turn the attachment B 180 degrees and slide the attachment B onto the cylinder E and tighten wing knob D at desired depth (Fig. 5).
FIG. 1
A
FIG. 2
C
B
FIG. 3 |
B |
D |
FIG. 4
F
B 
FIG. 5
E
2610958467 04/09 | Printed in Mexico |