Harbor Freight Tools 68148 Grounding, Double Insulated Tools Tools With Two Prong Plugs

Page 6

GROUNDING

TO PREVENT ELECTRIC SHOCK

AND DEATH FROM INCORRECT GROUNDING WIRE CONNECTION:

Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.

Do not modify the power cord plug provided with the tool. Never remove the grounding prong from the plug. Do not use the tool if the power cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.

Double Insulated Tools: Tools

with Two Prong Plugs

Outlets for 2-Prong Plug

1.Tools marked “Double Insulated” do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code.

2.Double insulated tools may be used in either of the 120 volt outlets shown in the

preceding illustration.

(See Outlets for 2-Prong Plug.)

Extension Cords

1.Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord.

2.As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage.

(See Table A.)

3.The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord. (See Table A.)

4.When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum wire size required. (See Table A.)

5.If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size. (See Table A.)

6.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

7.Make sure the extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.

Page 6

For technical questions, please call 1-800-444-3353.

SKU 68148

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Demolition Hammer Save this ManualSave this Manual Important Safety InformationGeneral Power Tool Safety Warnings Save all warnings and instructions for future referenceFor technical questions, please call Breaker Hammer Safety Warnings Keep cutting tools sharp and cleanVibration Safety Save These InstructionsGrounding Double Insulated Tools Tools With Two Prong PlugsExtension Cords Symbology 25’ 50’ 75’ 100’ 150’Instructions for Putting Into USE SpecificationsUnpacking FunctionsOperating Instructions Tool Set UpWork Piece and Work Area Set Up General Operating InstructionsMaintenance Servicing Maintenance, and LubricationReplacing Carbon Brushes Cleaning TroubleshootingProblem Possible Causes Likely Solutions Parts List Part Description QtyAssembly Diagram Limited 90 DAY Warranty Record Product’s Serial Number Here
Top Page Image Contents