i. Tech Dynamic Bluetooth Clip Headset Getting Started, Charging Your Headset, Using Your Headset

Getting Started

Before using your i.VoicePRO (“headset”) for the first time, please ensure that

1.the headset is fully charged;

2.the fully charged headset must be paired and connected with a Bluetooth mobile phone.

Charging Your Headset

The headset comes with a built-in rechargeable battery. Prior to using the headset for the first time, you are recommended to fully charge the battery.

USB Charging Socket

Use only the supplied charger to charge the headset.

4

Charging Your Headset (cont’d)

Status	Status Indicator	Audio
• Charging	• Red light
• Fully charged	• Blue light
• Low battery	• Flashing red light	• a short beep every 1 minute
• Out of battery	• The light goes off

♦3 hours are required to fully charge the headset.

♦Charging indication will be delayed for a few seconds if the headset has not been used for a long time or the battery is drained.

Pairing Your Headset with a Bluetooth Mobile Phone

1)Ensure the headset is off.

2)To activate the pairing mode, press and hold the headset’s MFB for 8 seconds without releasing your finger until its status indicator flashes blue and red light alternately.

3)Activate your mobile phone’s Bluetooth, search Bluetooth devices, select “i.VoicePRO”

and enter the passcode “0000”. If your mobile phone supports Bluetooth v2.1 “Simple Pairing” function, no passcode is required. When the pairing is completed, the headset’s

status indicator will flash blue light rapidly five times.
If the pairing cannot be completed within three minutes after the pairing mode has been
activated, the headset’s status indicator will flash purple rapidly five times and then turns	5
off. Repeat steps 1 to 3 to pair both devices again.

Pairing Your Headset with Two Mobile Phones (Multipoint)

i.VoicePRO supports a Multipoint function to allow simultaneous pairing of the headset with two mobile phones.

1.Follow the pairing procedure as instructed in “Pairing Your Headset with a Bluetooth Mobile Phone” to pair the headset with the first mobile phone.

2.Repeat the pairing procedure for the second mobile phone.

3.On the first mobile phone’s menu, activate its Bluetooth connection with the headset.

Using Your Headset

Function	Button	Audio	Status Indicator
Power ON	Press and hold the MFB for 2	a short beep	Flashing blue light 3
	seconds		times

When you turn on your headset for the first time, the headset automatically enters the pairing mode, i.e. the status indicator flashes blue and red alternately. This allows you to immediately pair your headset and mobile phone.

Power OFF	Press and hold the MFB for 2	a long beep	Red light for two seconds
	seconds		and then the light goes off

6

Using Your Headset (cont'd)

Function	Button	Audio	Status Indicator
Answer a call	Press the MFB once		Flashing blue light
End a call	Press the MFB once		Flashing blue light
Adjust Volume	Press the Volume Key once to	a short beep	Flashing blue light
	increase / decrease by 1 step
	(Total 6 levels)
Voice Dialing	Press the MFB once	a short beep	Flashing blue light

Say the voice tag as soon as you hear the short beep and you must have recorded the voice tag into your mobile phone.

Last No. Redial	Double click the MFB		Flashing blue light
Call Reject	Press and hold the Volume Key	a short beep	Flashing blue light
	for 2 seconds
Call Transfer	While speaking, press and hold		Flashing blue light
(headset to mobile phone)	the Volume Key for 2 seconds
Call Transfer	While speaking, press MFB once		Flashing blue light
(mobile phone to headset)

7