INSTR_800-2705-0_1MCP.qxd 9/26/05 10:59 AM Page 4
NOTE: The glass lens is not attached to either housing. Use care when disassembling to avoid breaking lens.
FIGURE 3
Connector
FIGURE 4
Connector
FIGURE 2
Step 4: Disconnect bulb wire from connector by holding the connector firmly with fingers then pulling bulb wire straight out as shown in Figure 2.
Step 5: Squeeze the wire retainer together and lift up as illustrated in Figure 3.
Step 6: Pull bulb straight out from the reflector mounting plate.
Step 7: To install new bulb, grasp the bulb from the metal end (DO NOT TOUCH THE GLASS PART) and insert into the reflector mounting plate. Align the slots in the bulb base with those in the reflector mounting plate.
Step 8: Replace wire retainer by squeezing ends together while pressing down. Release ends so that they catch on the reflector mounting plate.
Step 9: Reconnect the bulb wire to the connector as illustrated in Figure 4.
Step 10: To reassemble, place the left housing down on a flat surface. Set the reflector into the left housing. Insert the right housing onto the left housing of the spotlight.
Step 11: Replace screws that were removed in Step 2. Do not overtighten screws.
Replacement bulbs and accessories may be purchased from The Brinkmann Corporation Consumer Sales Department by calling
3