OPERATING INSTRUCTIONS
The
white LEDs. The
utilizing 2 channels.
Master/Slave & Stand-Alone Mode
The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In
this mode, the first unit in the daisy chain will automatically command all other units following.
1.Connect all
IN | DMX512 | OUT |
|
|
|
|
|
| ON | 119 | 9 | ||
|
| ON | ||||
|
| 8 7 6 5 4 3 2 1 | 0 | 8 7 6 5 4 3 2 | 10 | |
2.Master Unit: Set dipswitch #10 to OFF.
3.Slaves: Set dipswitch # 10 to the ON position and all others to the OFF position.
Master Setting
FUSE POWER | POWER |
IN AC | OUT AC |
4.You can also run the fixtures in an automatic
IN | DMX512 | OUT |
|
|
|
|
|
| ON | 2 19 | 9 | ||
|
| ON | ||||
|
| 8 7 6 5 4 3 2 1 | 0 | 8 7 6 5 4 3 | 10 | |
fixtures to run as master units. | Slave Setting |
| |
FUSE POWER | POWER |
IN AC | OUT AC |
Daisy Ch ai n Conn ecti on
1.Connect the (male) 3 pin connector side of
the DMX cable to the output (female) 3 pin connector of the first fixture.
2.Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
Optional DMX Controller | Use |
|
IN DMX512 OUT | IN DMX512 OUT | IN DMX512 OUT |
10 9 8 7 6 5 4 3 2 1 | 10 9 8 7 6 5 4 3 2 1 | 10 9 8 7 6 5 4 3 2 1 |
Continue
IN DMX512 OUT
10 9 8 7 6 5 4 3 2 1
FUSE POWER
IN AC
AC Line
POWER | FUSE | POWER | POWER | FUSE POWER | POWER | FUSE POWER | POWER |
OUT AC |
| IN AC | OUT AC | IN AC | OUT AC | IN AC | OUT AC |
Use AC linking cable for convenience. As many as 50 par cans | Continue |
| |
can be powered from one AC daisy chain connection. |
|
7 |