Trouble Shooting

If you have a problem with you cleaner, consult the handy guide below. If the cleaner is malfunctioning, do not operate it before asking for service.

		Clean the filter and empty the dust cup.
Noisy operation		Clean or replace the filter.
Low Suction		Remove the blockage.
		Put the dust cup in place.
Over-heating/		Clean the filters, and empty the dust cup. Check for
Automatically		blockages and unblock and allow it to cool.
Stopping		Plug unit firmly.

Cannot Find	the	Nozzle is clipped into a compartment at the bottom
Combination		edge on the back of the vacuum cleaner (between
Combination		the wheels).
Nozzle		the wheels).
Nozzle		It is a single attachment.
		It is a single attachment.

		Due to the strong suction power, it may be difficult
		to push, especially thick carpet. Rather than force to
		use the floor brush, lift up the Floor Brush
Floor Brush	hard	momentarily to allow air to flow into the vacuum
to push		releasing to the built up suction pressure , then do
to push		well to push floor brush.
		well to push floor brush.
		Slide and open the suction adjusting plate located
		on the hose handle grip. This will reduce suction
		power of the floor head.
Cord doesn’t fully		Pull out the cord and rewind again.
rewind

Made in China