FUNCTIONAL DESCRIPTION
ATTACHING AUXILIARY HANDLE
5
4
7
3
8
CONTROLS AND COMPONENTS:
1.ON/OFF Switch with Locking Tab
2.Tool Body
3.Protective Guard
4.9" Grinding Wheel
5.Spindle Lock Button
6.Power Cord
2
6
1
9
3
10
ACCESSORIES:
7.Side Handle
8.Pin Spanner
9.Hex Wrench
10. 7" Grinding Wheel
This tool comes with an auxiliary handle which can be attached to the left, right or top side of the Angle Grinder, depending on the prefer- ence of the operator. This handle is necessary to maintain complete control of the tool and should be used at all times. Make sure this handle is always fastened securely.
ATTACHING WHEEL GUARD
Never brush or grind without the guard in place. Brushes are considered to be grinding wheels and must also be used with guards.
•Always unplug the tool before attempt- ing to change the guard or accessories.
• Set the Angle Grinder on a flat surface with the spindle facing up.
• Place the spring washer of the guard over the spindle.
COMPONENT | MODEL NUMBER |
Pin Spanner | 690157 |
ASSEMBLY
Make sure you have full control of the tool when grinding into a corner as a sharp, sudden movement may occur when the wheel contacts a secondary surface.
• Tighten the screw of the spring washer.
• Make sure that the guard is secure- ly tightened in place.
Wheel size MUST match guard size. A 7" wheel may not be used in a 9" guard.
9