VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified on the nameplate of the tool. A power source with voltage greater than that specified for the tool can result in SERIOUS INJURY t o the user - as well as damage t o the tool. If in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage less than the nameplate rating is harmful t o the motor.
ADDITIONAL SAFETY RULES
1.Keep guards in place.
2.Use only wheels having a maximum operating speed at least as high as "No Load RPM" marked on the tool's nameplate. When using depressed center wheels, be sure to use only
3.Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately.
4.Use only flanges specified for this tool.
5.Be careful not to damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage.
6.Hold the tool firmly.
7.Keep hands away from rotating parts.
8.Make sure the wheel is not contacting the workpiece before the switch is turned on.
9.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel.
IO. Use the specified surface of the wheel to perform the grinding.
11.Watch out for flying sparks. Hold the tool so that sparks fly away from you and other persons or flammable materials.
12.Do not leave the tool running. Operate the tool only when
13.Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin.
SAVE THESE INSTRUCTIONS.
4