Global Machinery Company NTS2000A, BG150VS Adjusting the height, Cleaning, General inspection

Page 10

13.Position the hook on the front of the bench grinder support plate and secure using the pan head screw and flat washer.

WARNING! DO NOT fit the bench grinder to the stand until the stand is bolted through

or into the floor. This stand

is not designed to be a free standing stand, and the base must be secured to the floor or area where the stand will be positioned. Do not fit the grinder or operate the grinder without the base being firmly attached as it will tip over.

Adjusting the height

WARNING. Always ensure that the bench grinder is removed from the bench grinder support plate before adjusting the height.

1.Loosen the tension handle.

2.Whilst holding the bench grinder support plate rotate the support plate in a clockwise direction to disengage the height location.

3.Raise or lower the support plate to the desired height.

4.Rotate into the nearest height location by rotating the support plate in an anti-clockwise direction.

5.Tighten the tension handle to secure the pole and support plate in position.

IMPORTANT. It is important to ensure the adjustable stand is correctly located into one of the pre set height positions. Do not attempt to use the stand if it is not correctly located.

Cleaning

1.Re-lubricate all moving parts at regular intervals.

2.Never use caustic agents to clean plastic parts.

CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended.

General inspection

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

Troubleshooting

Trouble

Problem

Suggested remedy

 

 

 

Vibration or

Loose parts

Check to see that all

abnormal noise

 

screws are secure.

 

 

 

10

Image 10
Contents Bench Grinder Stand Contents Introduction SpecificationsGeneral safety rules Environmental protectionPower tool use and care Do not use the power tool if the switch does not turnPage Unpacking AssemblyRequired Tools Components Know your product Assembly Troubleshooting Adjusting the heightCleaning Trouble ProblemPage GMC customer assist