EN G L IS H
INTENDED USE
Your DW820 angle grinder has been designed for professional grinding applications.
DO NOT use grinding wheels other than centre depressed wheels and
DO NOT use under wet conditions or in presence of flammable liquids or gases.
These
•This product is not intended for use by persons (including children) suffering from diminished physical, sensory or mental abilities; lack of experience, knowledge or skills unless they are supervised by a person responsible for their safety. Children should never be left alone with this product.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate.
Your DEWALT tool is double insulated in accordance with EN 60745; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available through the DEWALT service organisation.
Mains Plug Replacement (Middle East and Africa)
If a new mains plug needs to be fitted:
•Safely dispose of the old plug.
•Connect the brown lead to the live terminal in the plug.
•Connect the blue lead to the neutral terminal.
WARNING: No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved extension cable suitable for the power input of this tool (see Technical Data). The minimum conductor size is 1 mm2; the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.
Attaching Side Handle (fig. 2)
WARNING: Before using the tool, check that the handle is tightened securely.
WARNING: The side handle should always be used to maintain control of the tool at all times.
Screw the side handle (d) tightly into one of the holes (f) on either side of the gear case.
Mounting and Removing the Guard (fig. 3)
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.
CAUTION: Guards must be used with this grinder.
TO MOUNT THE GUARD
1.Place the angle grinder on a table, spindle up.
2.Press the guard (c) down (fig. 3A).
3.Position the guard between your body and work piece.
4.Tight the screw (l) holding the cinch collar firmly around the neck of spindle (fig. 3B)
TO REMOVE THE GUARD
1.Loosen the screw (l) holding the cinch collar around the neck of the spindle.
2.Lift up on the guard.
Fitting and Removing a Grinding Disc (fig. 1, 4, 5)
WARNING: Do not use a damaged disc.
7