Grizzly instruction sheet Model H0588, ⁄4 Angle DIE Grinder, Instruction Sheet

MODEL H0588

1⁄4" ANGLE DIE GRINDER

INSTRUCTION SHEET

EYE INJURY HAZARD!

Always wear safety glasses

when using this tool to prevent serious personal

INJURY HAZARD!

Always disconnect tool from

air to prevent unexpected operation during service.

EXPLOSION HAZARD!

Never exceed 120 PSI.

Introduction

Angle Die Grinders are excellent for reaching sideways into areas that are relatively confined. No-load speed is 18,000 RPM and collet size is 1⁄4". Requires 90 PSI with 4 CFM of compressor capacity. Air inlet is 1⁄4" and air exhaust is in the rear. Weighs just over 1 lb.

Figure 1. Model H0588.

Quick	Quick	Lubricator
Connector	Connector		Regulator
Your			Air
Tool			Compressor
Quick
Coupler		Quick
	Air Hose		Filter
		Coupler

Inventory
A.	Die Grinder	1
B.	Flat Wrench 17mm	1
C.	Flat Wrench 12mm	1

Operation

Tool requires 90 PSI to operate correctly.

To improve tool lifespan, use a filter/lubricator/ regulator as shown in Figure 2. Otherwise, lubri- cate daily with a couple drops of pneumatic tool oil directly into the air fitting as shown in Figure 3.

Figure 2. Installing your tool.

Figure 3. Lubricating directly into air fitting.

If you need help with your new pneumatic tool, call our Tech Support at: (570) 546-9663.

COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#KM7957 PRINTED IN TAIWAN