Lubrication
The grease in the gearbox will require replacement after extensive use of the tool. Please go to a qualified service agent to perform this service.
Power cord maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a rag. Wear safety goggles or an eye shield and gloves whist cleaning.
3.
4.Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended. Water must never come into contact with the tool.
General inspection
Regularly check that all the fixing screws are tight, particularly the outer flange. They may vibrate loose over time.
10