section under the screw head fits into the slot of the tool rest. Fit the star washer and then the large flat washer.
3.Fit the plastic coated thumb nut to the screw and tighten the nut sufficiently to support the tool rest but still allowing
the tool rest to slide inward and outwards.
4.Slide the tool rest to within a max of 1.5mm from the wheel. Rotate the wheel one full revolution by hand to ensure the wheel does not contact the tool rest.
5.Tighten the thumb nut firmly to retain the assembly.
Repeat the assembly operation for the second grinding wheel.
Important. Ensure that the washers as shown in the photograph are correctly positioned.
Bench mounting the grinder
The GMC Bench Grinders are supplied with 4 rubber suction caps which assist in reducing the transmission of vibration.
It is strongly recommended that the grinder be firmly mounted to a bench or stand for safe operation.
The base of the grinder has a 7mm hole in each corner. These holes accept screws or bolts up to 6mm diameter. Mounting screws are not supplied with the unit.
Where the grinder is to be mounted on to a steel work bench, it is advisable to place a piece of timber between the bench and grinder then screw or bolt through the grinder and timber into the bench. This further assists to reduce vibration.
Important. When directly mounting the grinder ensure:
•The surface under the grinder is flat and clean.
•The 4 mount screws are applied evenly and not over tightened.
Note. The four rubber suction caps should remain in place if mounting screws are used.
Using the On/
Off switch
1.To turn the grinder on, press the top of the rocker switch (6) marked “I”
2.To turn the grinder
off, press the bottom of the rocker switch (6) marked “O”.
Operation
Important. Prior to using the grinder, check that the eye shields and tool rests are fitted and correctly adjusted and that you are wearing safety gear including eye, hearing and breathing protection.
1.Turn the wheel by hand to make sure it does not touch the guard and runs freely.
2.Stand to one side, turn the switch (6) on and allow the motor to reach full speed.
3.Support the work piece on the tool rest (7) and gradually feed the work piece onto the wheel. Use pliers to hold small work pieces.
Note. Traverse the work piece across the full width of the wheel to prolong its flat surface.
4.If the grinding operation causes the motor speed to noticeably decrease, pull back the work piece, allow the motor to regain full speed and restart the grinding operation, but apply less force.
Warnings. Only use the front face of the grinding wheel, not the sides. Note that the work piece can get very warm. It may be necessary to cool a work piece by dipping it in a coolant or in water. Do not apply coolant or water to the grinding wheel.
9